OCR Text |
Show Convenient Method of Forcing Brass Bushing Driving a bronze or brass bushing Into place with a wooden mullet often Is difficult and always Is hard on the mallet. A much simpler way to force the bushing Into place Is shown In the Illustration. Make up a special bolt with the shank slightly smaller than the hole through the bushing. The shoulder on the bolt should be square so that It will not Injure the edge of the hole. By turning the nut you can pull the bushing Into place easily. STtESING LARGE (NUT STEtRINS ARM rush, NO V 6EARIN0 f Tl fJTV.SHOOLOER- CN &CLT LJ Simple Method of Forcing Bushing Into Place, Using Special Bolt With Nut and Washer. This method of Insert Ins a bushing often Bill save dismounting the part to get it Into the arbor press nnd may permit a Job to be done where the shape of the part Is such that It Is hard to get at with the press. Hesr results will be obtained If the bolt Is cut with a fine thread. Note that when a bushing Is forced Into place the hole actually Is reduced re-duced in size sufficiently to cause a Jam if the bolt Is made too close a fit Popular Science Monthly. |